ANSWERS TO MOST FREQUENTLY ASKED QUESTIONS AND ADDITIONAL STRATEGY TIPS
7/5/94
(This document summarizes the hints and tips from various sources.)
* SEED FACTORY AND ROBOMINER PLACEMENT
Use the Elevation Map on the site map window to choose a landing area.
The clear terrain is marked in black, so the best locations are black
with red diamonds (which mark potential mines identified from orbit).
When you place the Seed factory, a red "X" will appear on the diamond
shaped tile map. Run a turn by left clicking on the small planet in
the lower right hand corner of the screen, then the turn number will
appear below the planet. When you see the Seed lander on the map (in
place of the red "X"), you can start running turns to get the Seed factory
started. Construction tiles and pre-fabricated tubes will appear.
While the Seed factory is building itself, place a robominer from the
tile selector window on one of the red mining beacons nearby. If you
don't see a mining beacon, scroll to that position on the map by clicking
on the tile map arrows and watch the box on the site map to line it
up with a red diamond. When you place a robominer on the red mining
beacon, you will see the robot replace the beacon. It will take several
turns for the first level of the mine to be dug, after which it will
automatically move resources to the Seed factory.
As you run your first turns, keep using the robodozer to clear terrain
around your Seed factory. Also place a robodigger at the end of one
of the tubes at the Seed factory construction site so that it can start
digging your first underground level. When the robodigger is finished
digging, the robodigger on the map will be replaced with the top of
an air shaft.
* BUILDING WITH TUBES
Tubes carry air and power from your CHAP and power facilities. For most
structures, a tube connection is required to physically connect them
to your existing network of buildings and tubes. Since construction
also requires a tube connection on a tile adjacent to your intended
building site, you may find that nothing is available in your tile selector
window except for robots and tubes.
After placing a tube on a bulldozed section of the diamond-shaped tile
map, structures will then appear in the tile selector window if resources
are available to build new structures. When your colony is just starting,
tubes will not be available in the tile selector window until you have
brought down your first colonist lander.
* IF THE TILE SELECTOR WINDOW IS EMPTY
During construction of your colony, there may be times when the tile
selector window is empty. This means that all the robots are actively
assigned to tasks on the tile map, and that no resources are currently
available to construct new buildings. Running a few turns will remedy
this situation.
* EARLY CONSTRUCTION
In the Construction section of the manual, it is suggested that you
build your first few structures in this order: Agricultural Dome, CHAP,
power facility, storage tanks, residential units. If your morale is
falling fast, you may want to build a residential unit or two to slow
the fall of morale before you build a power facility (since the Seed
provides power for about 150 turns).
During the first 50 turns or so, you should build SLOWLY---allow each
of your first structures to finish building before starting a new one.
While structures are building, you can always bulldoze, mine, and tunnel
horizontally or vertically with your robodiggers (assuming you have
these robots available when you want them).
Because a SPEW facility provides resources from the sewage generated
by residential units, this is also a good structure to build early
on, along with a warehouse and a robot command facility to make use
of robots built by your Seed factory. Gradually add more mines to keep
your resources flowing.
Remember that an operating SPEW will generate MPG, which will take the
place of any resources you may temporarily be missing. MPG is stored
at the SPEW facility and used automatically when necessary to maintain
existing structures. You can check the amount of MPG you have in storage
by left-clicking on the SPEW facility to get its report.
* SEED FACTORY COLLAPSE
Remember also that you will lose your Seed factory units (power, smelter,
robot factory) after 150 turns, so you must build structures to account
for this loss if you want to maintain those functions.
Before the Seed factory units collapse, make sure that your tube connections
will be maintained between structures. Tubes are required to carry
power and air, both for construction of new buildings and maintenance
of those buildings. You need a constant physical connection of buildings
and tubes to keep supplying power and air to all of your structures,
so there must be tubes that bypass your seed factory units by the time
the Seed factory units collapse.
* SAVE GAMES
Note that games can only be saved from the main game screen where you
see the diamond-shaped map. If you encounter a problem saving a game,
try running another turn before you select the Save Game option. This
will complete the internal processing steps required so that you can
save the current state of the game. Running a single turn is accomplished
by left-clicking on the small planet icon in the lower right-hand corner
of the main game screen. This screen is the only place where games
can be saved.
* USING THE ROBOTS THAT LANDED WITH YOUR SEED FACTORY
Your seed factory landed with three robots on board: a robodozer, a
robominer, and a robodigger. While the seed factory is building itself,
these three robots can be assigned to tasks on the diamond-shaped tile
map that dominates your screen. When available, these robots are visible
in the tile selector window at the top center of your screen.
When you first place your robots, it's wise to place a robodigger adjacent
to one of the tube openings that are part of the seed factory complex.
The robodigger will then start digging a shaft to create your first
underground level.
Place a robodozer beside one of the other tube openings to prepare a
building site. Place the robominer on a red mining beacon (described
in the Seed Factory and Robominer Placement section). When you have
placed all of these robots, the tile selector window will be empty.
You must run turns to complete the current activity by those robots.
As each robot completes an activity, it will reappear in the tile selector
window for reassignment to a new task.
Explorer robots perform their function automatically. Each explorer
is capable of finding new mines, assuming they have not all been discovered
yet. The starship locates a large portion of a planet's potential mine
sites; the geological penetrator probes discover more potential mine
sites; and the hardest mine sites to locate can be discovered by explorer
robots. On the easy difficulty level, ten explorers are sufficient
to discover the remaining mine sites.
* BUILDING ROBOTS WITH YOUR SEED FACTORY
Once the construction of your seed factory is completed, you can use
it to build additional basic robots. Familiarize yourself with each
unit of the seed factory by left-clicking on each of the finished units
to read the report that identifies its individual function.
When you select the robot factory portion of the seed factory, you can
start building additional robots. There is a text entry area on the
robot factory report which has a small arrow to its right. Clicking
on the arrow button will pull down the robot production menu. The seed
factory can only produce these types of robots. By selecting one of
these robot types and closing the report, you have set the factory to
produce one of those robots every five turns. After you've built one
or more of a single robot type, you can go back to this same report
and reset production to build a new robot type.
New robots must be stored in a warehouse. Usually, one warehouse is
sufficient to handle robot storage for a long time, since active robots
in the field require no storage. Active robots will last for 200 turns,
which is the limit of their fuel cell power capacity. You must have
at least one warehouse to store the robots that your seed factory is
building, otherwise nothing will happen. Then, to activate the robots
from your warehouse, you must also build a robot command center (described
below).Each robot command center can operate ten robots in the field.
* BUILDING NEW ROBOTS WITHOUT THE SEED FACTORY
The seed factory can keep producing robots right up to the end of its
lifetime, which occurs around turn 151. For this first phase of the
game, seed factory robot production will often be sufficient for your
robot needs. However, at some point you may decide to build more.
A surface factory is required to build more robots. After turn 151,
this is your only option for building new robots. Active robots have
a life of 200 turns before their fuel cells die, so you'll start losing
them after turn 200, if you haven't already lost any due to accidents.
* ACTIVATING NEW ROBOTS WITH ROBOT COMMAND
However they are produced, new robots need to be stored in a warehouse,
from which they are available to robot command units. Each robot command
facility can operate ten robots. If you want to operate 11 robots,
you will need to build a second robot command facility.
If a robot factory has produced robots, and a warehouse exists to store
the robots, and at least one robot command facility exists to operate
ten of the robots, they will appear in your tile selector window so
that you can place them on the tile map. If all of the currently available
robots are active, no robots of that type will appear in the tile selector
window.
The radius of a robot command area is unlimited if you have a communications
satellite in orbit (assuming you packed one when you left Earth). If
you have no communications satellite, communications towers must be
built to extend the range of your robominers and other robots. Each
robot command facility and each communication tower have a communications
radius of 30 tiles.
* ROBODIGGERS AND ROBOMINERS
To extend a mine shaft to a deeper level on planets where this is possible,
place a robominer directly on an existing underground mine shaft. This
will not affect the functioning of the existing mine.
To extend an air shaft to a deeper level on planets where this is possible,
place a robodigger directly on an existing underground air shaft.
* WHEN ROBODIGGERS DIG
On the surface of the planet, a robodigger can only dig a new level
when it starts next to a surface tube connecting it to its home colony.
Because the robodigger constructs the air shaft for the underground
levels, the tube connection is required to carry air and power to underground
structures.
* WHEN PEOPLE ARE DYING TOO FAST AFTER LANDING
It is often wise to leave your colonists in orbit for the first 20 turns
while your Seed factory and its robots are doing their jobs to get the
colony started. This number will vary somewhat depending on how much
life support and food you brought with you on the starship (you packed
it at the Ship Configuration screen before leaving on the trip to the
new planet).
After you bring your first colonist lander down to the surface of the
planet, you have about 20 more turns in which to make sure that a CHAP
facility is built. Some people may die in the meantime due to accidents
or old age, depending on the hostility level of the planet you've chosen.
* WHEN BUILDINGS GO IDLE
Buildings go idle due to lack of resources, power, or people. In the
case of laboratories, they can also go idle if they are not assigned
a specific line of research.
If a particular structure's report shows its status as "idle," you can
find out what resources it needs by clicking on the "Needs" button at
the bottom of the report. (In the case of the CHAP facility, the CHAP
facility report is reached through the Executive Summary Report buttons).
CHAP facilities and power facilities are at the top of the priority
list when resources are scarce, allowing you time to react to the resource
shortage. Bulldoze unnecessary structures, particularly if you have
an operational SPEW facility to recycle the bulldozed building materials.
Make sure you have operating mines, an operating smelter, and sufficient
space in your storage tanks to handle the processed resources coming
into your colony.
If buildings are only idle due to a lack of people to operate them,
you can bulldoze unnecessary structures to free up employed workers,
or wait for your population to grow and age so that you have a larger
available work force. They will all age as you run each turn.
* POPULATION DISTRIBUTION
In the Executive Summary Report, you'll find a "Details" button in the
population section. Clicking on this button shows you the current breakdown
of your population by category: infant, student, worker, scientist,
or retired.
You will witness population explosions on occasion. This will be apparent
when you see more infants and/or students than workers or scientists.
Workers and scientists are required to operate your facilities, so this
is a limiting factor to your colony expansion. Only time will age your
young people to the point where they become workers and scientists.
Universities help to shift the student and worker groups into the scientist
group by bringing up the general educational level of the population.
It is not possible to assign the adult population to specific tasks.
One of the limits on building new structures is whether or not enough
colonists are available to build them and staff them. If they are available,
they will be assigned to those structures automatically when you build
them.
* WHY PEOPLE DIE
People die naturally from old age or by accident. These deaths will
occur no matter what you do. Deaths also occur due to starvation or
lack of air, and these are the deaths you can do something about.
When you receive a death message after running a turn, it may not mean
you're doing anything wrong. Check to make sure that you have enough
food being produced by your agricultural domes (one unit feeds ten people),
and that your structures are getting enough air. If you have handled
those requirements, then you know they're dying due to old age or accident.
After turn 60, deaths by old age or accident are reduced because the
first part of the colony has been built, the weakest people who survived
the trip have already died in the hostile environment, and construction
accidents are fewer because the workers have learned safer techniques.
* RESOURCE MOVEMENT FROM MINES TO COLONY SMELTERS
Mined ores are stored at each mine shaft until a full load is ready
to be moved by the truck assigned to that mine. When built, each mine
has one truck to automatically move ores to the Seed factory smelter
or to the high-capacity smelter you can build yourself. Storage tanks
are also required to receive the smelted resources and make them available
to the colony. You won't see these trucks operating, but they're on
the job.
* TRUCKS
Trucks can be produced by your surface factories. These trucks will
make a slight difference in the speed of your resource movements between
the mines and the smelters and the storage tanks. These trucks are
not affected by the robot command facility limit of ten robots each.
Internally, a truck is created to serve each mine when new mines are
built. Any trucks you build will remain in your warehouses unless one
of these mine trucks breaks down, at which time your trucks will be
used automatically. On the easy difficulty setting, it is possible
to get through most or all of a game without using these trucks.
* ROADS AND MONORAILS
Although there are no roads or monorails in this version of Outpost,
resources are moved automatically from place to place as necessary.
Each mine has a truck assigned to it when built, which will move a new
load after enough ore has stacked up at the mine.
* SOUND CARDS
Any sound card supported by Windows will work with Outpost. During
the Installation process, the question regarding the Roland sound cards
(MT-32, etc.) is asked so that the special music file for those sound
cards can be loaded instead of the standard music file.
